one. Cleaning the pre-separation belt flushing faucet, cleaning the main takeoff and upper netting belt flushing faucet
Reasons for maintenance: If the flushing nozzle is blocked, the filter water and mud quality of the mesh belt will be disturbed.
Maintenance purpose: a cleaning work that must be done for the water filtration of the mesh belt.
The maintenance cycle is daily maintenance.
two. Clean and polish limit switch, clean pre-take off, main take-off and upper mesh belt to adjust the deflection and reversal width.
Maintenance reasons: Because the limit switch and the deflection valve are in the corrosive dehydrator, which also causes the limit switch and the reversing valve to be stuck, the limit switch and the reversing valve are stuck. The jam will also affect the tearing of the mesh belt or the complete destruction of the mesh belt.
Maintenance purpose: In order that the mesh belt can normally carry out the filter press work on the drive shaft, it will not run out of the drive shaft and avoid the tearing of the mesh belt to play a protective role.
Maintenance cycle is once every two days
Three Clean the dehydrator cloth mud.
Maintenance reasons: The cloth mud will fall off at the fixed position of the dewatering machine or leave the working position, which cannot evenly distribute the sludge entering the dewatering machine to the pre-separating belt.
Maintenance purpose: The maintenance work that must be done in order to better improve the effect of mud cloth and achieve uniform sludge distribution in the pre-separation belt.
The maintenance cycle is once a week.
Four. Main dehydrator for cleaning dehydrator and pre dehydrator for cleaning dehydrator.
Maintenance of the original garden: the long-term work of the motor and the high corrosiveness of the dehydration machine room will lead to the occurrence of unevenness of the body and the occurrence of corrosive short-circuits.
Maintenance purpose: to better extend the service life of the motor, to find problems in time and report them for processing.
Maintenance interval is every major
five. Clean the peripheral mask, cover plate, gas collection system, and screw conveyor of the dehydrator.
Reasons for maintenance: Because the equipment will be untidy during work such as refueling and burying the flushing faucet.
Maintenance purpose: a long-term work to better improve everyone's working environment and working mood.
Maintenance cycle is once a week
six. Clean the air compressor.
Maintenance reasons: The air compressor Changsi works in a humid working environment, and there will be a lot of water vapor in the air compressor, which will affect the life of the air compressor.
Maintenance purpose: In order for the air compressor to normally supply air to the dehydrator's deviation adjustment system, it is also a work done to prolong the service life of the air compressor.
The maintenance cycle is once a day.